Medium Wave Carbon IR Heat tube lamp

Medium Wave Carbon IR Heat tube lamp

Medium Wave Carbon IR Heat Tube Lamp: The Real Deal on Power, Physics, and What It Actually Does

We built the Medium Wave Carbon IR Heat Tube Lamp for engineers who need heat they can count on—fast, intense, and packed into a small space. This isn’t a general-purpose bulb. It’s a proper thermal tool, built for industrial heating, curing, and forming where speed and steady output matter.

Power, Voltage, Size: What You Actually Get

Here’s the core setup: a 400V, 2500W lamp that concentrates serious heat into a short length—about 300mm. That means you get a lot of output without needing a long heater hanging around. It’s straightforward physics. The carbon filament runs hot enough to peak in the medium infrared range, so the energy lands right where many plastics and coatings can soak it up. That wattage and voltage aren’t just numbers—they’re what make the lamp spool up quickly and deliver the radiant punch your process needs. But there’s a trade-off. Packing that much power into a small envelope means you have to manage the heat. Your machine needs airflow or a plan for reflected heat. If you don’t, you’ll shorten component life and lose stability when it matters most.

Built to Handle the Heat: Quartz, Coating, and a No-Nonsense Connector

We wrap the filament in a quartz tube because quartz takes rapid temperature swings in stride and stays clear and efficient in the IR range. The tube often gets a coating to fine-tune the spectrum and cut surface losses, which helps keep heating zones consistent. And that connector? It’s the R7s base for a reason. It gives you solid electrical contact and repeatable alignment, so you can wire it fast and seat it in a reflector or fixture without wobble.

Where This Lamp Shines: Real-World Applications

This configuration earns its keep wherever you need fast, localized heating—PET blowing, thermoforming, adhesive curing, drying lines. Medium wave IR matches well with materials that absorb heat efficiently, so you get shorter cycle times and cleaner control over heating zones. On the shop floor, it’s a drop-in piece: 400V, 2500W, around 300mm long, and an R7s interface. No redesign headaches. Size the power supply, plan the cooling, and you’re set. It just works.