Half White Reflector Carbon Fiber Heating Lamp: Power You Can Count On
We built this lamp for engineers who need serious heat, right where they need it, without taking up a ton of space. Think of it as your go-to workhorse for industrial heating, drying, and forming—when you’ve got to pack a lot of punch into a tight spot.
Why It Works So Well
Here’s the thing: we spec’d this lamp at 2500W and 400V. That gives you intense heat without forcing the system to pull too much current. And less current? Well, that means you can use smaller wiring and smaller contactors. It keeps your control panel clean and simple. The 300mm length is just right, too. It gives you a focused heating zone that fits into standard machine slots. So when you’re swapping out an old heater, you don’t have to redesign the whole enclosure. It just drops right in.
Smart Design, Built to Last
The half-white reflector coating is a real game-changer. It directs infrared energy forward in a tight pattern, so you lose less heat and keep nearby components safe. Inside, the carbon filament heats up fast and handles sudden temperature shifts way better than standard tungsten. And the R7s connector? It’s that solid, two-pin design that locks in tight, holds up against vibration, and makes wiring a breeze.
Where It Shines
This is the lamp you reach for when you need heat, and you need it now. Preheating plastic, curing adhesives, drying parts—it gets the job done quickly. Because it hits operating temperature fast, your cycle times stay short. Just keep one thing in mind: this is a 2500W lamp. It runs hot. So make sure your machine’s cooling and clearance are up to the task. Otherwise, you risk overheating nearby sensors and wiring. We built it to handle the rough and tumble of the shop floor, and to keep delivering steady, repeatable heat. If you need a heater that’s tough, reliable, and installs straight into what you already have, this one was made for you.