Twin tube quartz heater for Heidelberg

Tue, 28 Jul 2026 00:10:22 +0800

A Better Way to Handle Your Heidelberg and M&R Heaters

Let’s be honest: nobody likes spending a fortune on OEM replacement lamps just to keep the line moving. We’ve all been there. That’s why we built these twin tube quartz heaters. They’re designed to slide right into your M&R flash curing systems or Heidelberg presses without any fuss. The goal is simple. You need that high-intensity shortwave IR to set your inks fast, but you can’t afford to fry your substrate. The secret is in the “Twin Tube” setup. By putting two filaments inside one quartz envelope, we’ve doubled the surface area. This is a big deal. It means we can crank up the wattage without the tungsten filament hitting its melting point. The result? The heat spreads across your conveyor belt much more evenly. If you run them at high voltage, they heat up incredibly fast. Just a heads-up: higher power density puts more stress on your wiring and contactors. Just double-check that your electrical setup can handle that initial peak draw when you flip the switch. About the glass and the gas… We use high-purity fused quartz because it lets the IR light through without blocking it. Inside, there’s a halogen gas cycle. It basically catches the tungsten as it evaporates and puts it back onto the wire. It’s a clever little loop that keeps the lamp from burning out too early. Plus, we made sure the dimensions are a dead match for M&R. You won’t have to mess around with your reflectors or modify your heater bank. It just fits. Less downtime, more printing. Replacing those big-name brand lamps usually feels like a rip-off. Our tubes give you the same heat and spectral output, but they won’t break the bank. You can use your standard connectors and get back to work. Here’s the real world problem: these things get hot. Like, really hot. Usually, the seal between the quartz and the end-cap is the first thing to go because of all that expanding and contracting. We reinforced those seals specifically to handle that stress. It means your maintenance crew spends less time swapping out dead tubes and more time actually running production. That’s how it should be.

How to replace Heidelberg IR lamp

Thu, 09 Jul 2026 15:52:25 +0800

Introduction

Swapping out a Heidelberg IR lamp in your Adelco drying channel isn’t just a simple part replacement. It’s more like giving your heating setup a tune-up from the inside out. We built this replacement as a straight-in infrared upgrade for those long tunnel furnaces, where keeping a steady, even temperature across the whole conveyor is absolutely key.

Getting Into the Details

Here’s the thing with the Adelco-compatible IR lamps for tunnel ovens: they’re designed around a very specific power and shape. The 2500W rating hits just the right heat level to keep the process temperature steady, even on those long runs, without needing a bigger machine to make it happen. And the 400V electrical spec? That means less current draw than the lower-voltage options. So you can use smaller wiring and it makes the whole hookup in your existing cabinet a lot simpler. The 300mm tube length is intentional, too. It focuses the infrared heat into a tight zone, so you can line up a bunch of them down the tunnel. The result? Even heating with no hot or cold patches.

Heidelberg on IR UV Hub

Twin tube quartz heater for Heidelberg

A Better Way to Handle Your Heidelberg and M&R Heaters

How to replace Heidelberg IR lamp

Introduction

Getting Into the Details